Page Index Toggle Pages: 1 [2]  Send TopicPrint
 10 Silencers tetive (Read 6692 times)
Goran Pecinovic
Full Member
***
Offline


Halleluja

Posts: 126
Location: Paracin
Joined: Apr 1st, 2010
Gender: Male
Re: Silencers tetive
Reply #15 - Oct 22nd, 2011 at 7:04pm
Print Post  
Ja imam silensere od vune i super se pokazali.
Pravio sam ih ovako nesto
  
Back to top
 
IP Logged
 
Knezevic Milan
Senior Member
****
Offline



Posts: 373
Location: Užička Republika
Joined: Mar 18th, 2011
Gender: Male
Re: Silencers tetive
Reply #16 - Oct 22nd, 2011 at 8:09pm
Print Post  
  

Back to top
WWWGTalk  
IP Logged
 
B_R
Senior Member
****
Offline



Posts: 287
Joined: Aug 17th, 2011
Re: Silencers tetive
Reply #17 - Oct 22nd, 2011 at 10:39pm
Print Post  
Knezo, jel to otvaras prodavnicu, ili planiras kupovinu sledecih 300 lukova Cheesy

Mada, moze za grupnu kupovinu.
  
Back to top
 
IP Logged
 
Knezevic Milan
Senior Member
****
Offline



Posts: 373
Location: Užička Republika
Joined: Mar 18th, 2011
Gender: Male
Re: Silencers tetive
Reply #18 - Oct 22nd, 2011 at 11:16pm
Print Post  
pa uvek nekom meni dragom prijatelju moze zatrebati silencer
ps . rezervisano za lovce
  

Back to top
WWWGTalk  
IP Logged
 
Goran Arambasic
New Member
*
Offline



Posts: 41
Joined: Feb 25th, 2012
Re: Silencers tetive
Reply #19 - May 14th, 2012 at 8:39pm
Print Post  
Knezevic Milan wrote on Oct 10th, 2011 at 3:52pm:
Jel neko koristi ove prigusivace od vune , mislim jel ona deluje ? Prigusuje li , gumice rade , odlicno se istegnu i vibracija kao talas predje na njih.  Ove vunene , nemam pojma

Vuna, najbolja! Laka ne utice na iybacaj strele.A ja je postavljam, na trecinu.
  
Back to top
 
IP Logged
 
Knezevic Milan
Senior Member
****
Offline



Posts: 373
Location: Užička Republika
Joined: Mar 18th, 2011
Gender: Male
Re: Silencers tetive
Reply #20 - May 31st, 2012 at 2:24pm
Print Post  
videli ste na onom linku koliko kupih one gumetine "cat wiskers"
i ni jednom je nisam upotrebio , kradem od babe vunicu onu finu i od nje pravim  Smiley
  

Back to top
WWWGTalk  
IP Logged
 
Knezevic Milan
Senior Member
****
Offline



Posts: 373
Location: Užička Republika
Joined: Mar 18th, 2011
Gender: Male
Re: Silencers tetive
Reply #21 - May 31st, 2012 at 3:10pm
Print Post  
Heterodyning

This tip requires a bit of radio theory and brain-work. The subject is heterodyning. A very basic definition is two different frequencies that are combined to produce two new frequencies: the sum and difference of the two original frequencies. What does this have to do with traditional archery equipment? Well, knowing this fact helps us to quiet our bows.

Most of us have tried various types of string silencers. Some folks have trouble getting any of them to work. Here is the solution, no matter the type of bow or type of silencer material. Measure the distance from where the string leaves the bow limbs top and bottom. Divide that distance by four and also by three. For instance and simplicity let us say your measured length is 60 inches; divided by four equals 15 inches and divided by three equals 20 inches.

Attach your top string silencer 15 inches down from where the string leaves the bow, and attach the bottom silencer 20 inches up from where it leaves the bow. Doing so cancels out the sustaining frequencies that would make a naked string hum or twang when released. The quartering distance (15 inches) cancels out all even multiples of the frequencies and the distance in thirds cancels out all the odd multiples of the frequencies. The end result is a string that resists vibration after the shot and goes thump instead of twang.
tekst preuzet sa  bowshooter

da skratim , gornji silencer stavljate na prvu cetvrtinu a donji na prvu trecinu duzine tetive
  

Back to top
WWWGTalk  
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
 
  « Board Index ‹ Board  ^Top